Aero Bar Plugs
Introducing TriRig's unique, aero-shaped bar plugs. These plugs can be used either at the front of an extension (for 1x use), at the front of a base bar (for track use), or the rear of an extension. The hybrid parabolic bullet-tip shape is the most aerodynamic shape of any bar plug on the market.
Each set includes two closed versions, for use when cables do not need to be routed through the plug, and two open versions for cable routing. The open versions have a 4mm rear-facing port for standard cable housing, and a 2mm downward-facing port for electronic wires. This vertical port makes the TriRig Aero Bar Plugs the only product on the market to allow vertical routing of electronic wires, eliminating the 'wire loop' caused by standard rear-facing cable ports. The open ports also feature a split down the middle, meaning they can be installed before or after cables/wires are run.
A set of bar plugs is included with every Alpha One aerobar sold.
Snap-Top Water Bottles
No returns on Water Bottles.
We've used these bottles for over a decade, and absolutely love them. They are simple, effective, and reliable. Instead of a fancy slew of tiny parts that are prone to fail, they rely on a snap-top lid with a traditional friction-fit spout. We customized them with subtle TriRig graphics, and offer them in a 500mL or 750mL capacity.
TriRig Ultra-Low Dust Covers
No returns on Dust Covers.
These are the ultra-low-profile dust covers we developed for the Alpha X and Sigma X front ends. The replace the standard dust cap on your bike, allowing up to 30mm of stack reduction and a much cleaner look. Aerodynamically, it's usually preferable to slam your stem and achieve your pad stack via the use of aerobar pad spacers.
Now you can slam your stem all the way to the headset, safely and easily. These Dust Covers fit most 1-1/8" headsets. Each one is individually machined from T6-6061 aircraft-grade aluminum, media-blasted for a beautiful satin finish, hard anodized, and laser-etched with the TriRig logo. Each one includes four 0.25mm stainless steel micro-shims for spacing upwards if needed to clear your particular headset.
TriRig Speed Concept Clamps
No returns on Speed Concept Clamps
These clamps are compatible with the aerobars for the first-generation Trek Speed Concept 9-series (model years 2009 through 2013), and also compatible with the 2012 Bontrager RXL aerobar, which uses the same clamping hardware.
The clamps significantly clean up the front-end hardware of the Speed Concept or Bontrager RXL aerobar, reduce the bolt count from 14 to 4, and drop over 200 grams of weight in the process. Read the whole scoop here. Each clamp starts as a one-pound block of 7075-grade aluminum (stronger than the cheaper 6061 on stock parts). They're CNC machined down to just 26 grams each, then black anodized. They will accept any standard aftermarket extension. The optional top caps shown in the video are available if desired. You must use at least 5mm of spacers beneath these clamps (some Speed Concept bars have a 5mm spacer bonded to the bar already).
A note about the top caps: as shown in the video, their intended use is to be sandwiched between the clamps and your arm cups. They are NOT REQUIRED, and the clamps will work just fine without them.