The chart below shows the stack and reach information for the TriRig Omni with the included Alpha X aerobar, complete with the number of extension spacers and stem spacers used for each setup. Here's how to use the chart:

1-Use the dropdown box in the upper-right corner of the chart to select a bike size.

2-Find your Stack in the left-hand column of the chart, or the row that most closely matches your stack. Every cell in this row represents a way to set up the Alpha X on your Omni that will produce this stack number.

3-Each cell states the amount of Pad Spacers as well as Stem Spacers to use in order to hit your stack number.

4-In most cases, there will be multiple cells that can hit your stack. The best setup for your position will generally be the one with additional colored cells above AND below your selected cell. These cells represent room to move up or down in the future, merely by adding or removing Pad Spacers, which is generally the easiest way to make a position change.

5-Cells in blue represent a standard setup with the extensions over the bar. Cells in green represent the special undermount position, where the extensions are mounted below the bar.

6-Once you have selected a cell from your Stack row that represents your preferred position, look at the bottom of that column to the Reach section. The three rows of Reach cells show the reach to the center of the pad based on the three different adjustment positions available on the Alpha X arm cups. Select the one that most closely matches your Pad Reach number, and set up your pads/cups accordingly.

7-Note that fit numbers for the Omni w/ Alpha X are measured from the top/center of the headset to the top/center of the pad. All measurements for overmount hardware include the integrated BTA mount.