Beta Saddle Bracket Installation Guide

Beta Saddle Bracket — Installation 

⚠️ When This Bracket Is Required?

If your bike does not have native 10 mm Ritchey thru-rails, the Beta Saddle Bracket is required to mount the Beta Bottle Carriers (Beta One, Beta 45 or Beta 63).

---

Installation Steps

1. Position the Beta Saddle Bracket over the saddle rails.

2. Ensure the bracket clamps securely to the rails -- you can flip the bracket and use in right side up or upside down configuration.

🚨You must have at least 10 mm of exposed saddle rail behind the saddle clamp to install the bracket correctly.

3. Use either two M5 socket screws, torqued to 5-6nm

OR one singular M6 countersunk screw. Torque value of the M6 screw is saddle dependent, please check with your saddle manufacturer. 

4. Now that the Bracket is installed, connect to your desired Beta Bottle Carrier Rod. 

Tighten the two M5 buttonhead screws indicated by the blue arrows to 4-5nm.