Scoops Ultimate SL Installation Guide

Step 1 - Remove old arm cups from aero bar

Step 2 - Remove padding from TriRig Scoops by peeling back the velcro attached neoprene pad

Step 3 - Line up mounting holes on TriRig Scoops with mounting holes are your aero bar’s arm cup mounting bracket in desired location making sure you have the left and right Scoop on the correct side of your aero bar. Logos on the Scoops are intended to be facing outside of your arms. 

• Sometimes, however, the bolt patterns do not line up exactly where you need them to be for the fit you are looking for.  In this case we recommend our Wingspan adapter plates.  

Step 4 - Using the supplied hardware mount the Scoops to your aero bar. Only 2 bolts are needed for each arm cup. 

• We send different lengths of M5 and M6 width bolts. Find out which size your aerobar accepts and use the corresponding bolts from the hardware we sent with the Scoops. If you have a Trek Speed Concept, you will need to use our specific Speed Concept Hardware Kit

Step 5 - Tighten bolts to 6nm

Step 6 - Reapply velcro neoprene pad making sure the left pad goes with the left Scoop and the right pad goes with the right Scoop

Step 7 - Remove 4 bolts on extension clamp backing piece

Step 8 - Insert pre-cut extension to desired length and angle with a minimum insertion of 60mm (you can also use any other extension that you wish, you will just need to cut it down to fit the extension cavity in the Scoops Ultimate SL - make sure to follow the minimum insertion guideline no matter which extension you end up using)

Step 9 - Reattach extension clamp using the 4 bolts. Tighten to 4nm.

Step 10 - Install shifter to end of pre-cut extension.

Step 11 - Cabling is run externally. Run the cable from the shifter through the channel on the inner edge of the arm cup towards the back of the arm cup.